Dynalco 4-Digit Digital Tachometer Lighted - LST-108L

The Dynalco Digital Tachometer LST-108L is the lighted version of Dynalco LST-108 Tachometer. This high quality tachometer is specially designed to display very low speeds. It features a field-selectable pulse rate multiplier that can increase signal pulse rate by a factor of 10 or 100. It comes with standard SAE case that fits engine panels with 3.37-inch diameter openings. This unit also features a large, lighted, 4-digit LCD display with a gate time range of 0.13 to 2.85 seconds.

PRODUCT FEATURES:

• Standard SAE case fits engine panels with 3.37 inch (8.6 centimeter) openings
• Highly shock and vibration resistant. Gasketed and spray-proof
• Universal: Can be field-calibrated for any number of pulses per revolution from the sensor
• Ideal for OEM use. Can be paralleled with governors and/or speed switches
• High immunity to electrical noise
• Display contrast increases with increasing ambient light; ideal for both indoor and outdoor installation. Units are also available in lighted versions (LST-100L or LST-108L)
• The pulse rate multiplier increases input frequency which permits calibration at a much shorter gate time
• Tachometer can be factory configured for different input types i.e. TTL, CMOS, magnetic pickups, etc. Specify which type when ordering

PRODUCT SPECIFICATIONS:

• Dynalco Part No.: LST-108L
• Description: Digital Tachometer, Lighted
• Power Requirement: 10 to 30 Vdc or 115 Vac ±10%, 50/60 Hz, 8 mAdc typical. LST-100L and LST-108L are powered with 20 to 30 Vdc only
• Display: 4 active digits (0 to 9999), non-blinking LCD display, character height of 0.5 inch (1.3 centimeters)
• Input Signal Frequency: Signal frequency up to 10,000 Hz, except contact closure
• Contact Closure Input Option: 0-200 Hz
• Input Signal Voltage: 25 mVrms sensitivity for the standard unit which accepts zero crossing waveforms from pickups, generators, and pulsers. Nominal input resistance of 10 kOhms. Maximum permissible signal 50 Vrms. TTL option accepts unidirectional positive pulses from 0 to +5 volts, up to 0 to +15 volts
• Signal Common: Signal common is tied internally to the negative side of the dc supply
• Operating Environment: (operating) –5°F to +175°F(–20°C to +80°C); (storage) –40°F to +195°F (–40°C to +90°C )
• Accuracy: 1 RPM resolution, within ± 0.5% (± 0.1% typical at room ambient) under all combined environmental conditions
• Gate Time Adjust: Gate time is set by selecting one of four ranges on a switch and by a 25-turn vernier control potentiometer. Both controls are accessible from the back of the tachometer through a plugged hole
• Gate time ranges (LST-108 & 108L): (1) 0.13–0.36; (2) 0.36–0.72; (3) 0.72–1.43; (4) 1.43–2.85
• Recommended Magnetic Pickups: Dynalco Controls magnetic pickup M102 is used with the LST-100 Series in most applications. For very low speed applications the Dynalco Controls ultra high sensitivity M142 and the zero-velocity M910 are recommended. Refer to the Dynalco Controls Magnetic Pickups Brochure for a description of these and other pickups
• Weight: 0.8 pounds (0.36 kg)

Note: Actual image not shown. Same style only.